Tecnomac ChillTouch - Manual Chilling Operations; Manual Negative Chilling Operation

8
71504138-0-003
EN
3.4 - Starting the MANUAL Negative Chilling
In order to start the Manual negative chilling cycle, press
the icon [17] from the main screen. In order to stop at
any time the freezing, just press the key STOP [18]
Upon the rst start-up, the blast chiller will execute a
HARD temperature cycle and check, during the rst
two minutes, if the needle is inserted. If inserted, it will
continue to execute a temperature cycle or it will execute
a time cycle. During the insertion control, the needle will
ash. Afterwards, at any time, by pressing the symbols
[18a] and [18b], you can change the operation type (time
or temperature).
If the test is NOT exceeded, it will perform the execution
of a time cycle represented in the gure. If you want to
change the chilling time, just press above the countdown
value [19]
19
21
While, in the case of a temperature cycle, in order to
change the freezing end temperature set point, just press
above the value [21]
18
20
If you want to select another type of chilling cycle, just
press above the name of the execution cycle [20] and
a selection wheel will appear with the selectable cycles,
once the preselected cycle [22] is selected and ESC
[23] is pressed, the programme will acquire a new cycle.
22
23
Once the chilling time has elapsed or the chilling end
temperature is reached, the programme will pass
automatically to the preservation phase. In the centre,
the value read by the cell probe and in the lower part, the
summary of the performed chilling type and its duration,
used to set the dedicated chilling programmes, will be
displayed. In order to stop the cycle, press the key [24]
24
18a
18b
20
17