10
71504138-0-003
EN
4 - THAWING CYCLE
The defrost cycle has as its purpose to defrost a frozen
food item, guaranteeing health and therefore being
below the temperatures at which bacterial growth occurs
(above 10°C).
The cycle is composed of a rst pre-set time phase,
during which the cell temperature, the humidity and the
speed of the fans can be adjusted; and of a second
preservation phase with undetermined time.
In order to start the defrost cycle, press the key [25]
The following window will appear:
4.1 - Manual THAWING
In order to execute a manual cycle, press the bottom
key of the manual cycle [26], once pressed, the following
window will appear:
In order to change the set points, the window for
changing the value appears, it will be enough to press
above the displayed values. In order to change the cell
set point, just press above the value [27],, in order to
change the defrosting time, press above the value [28] .
You can also choose if the ventilation should be
continuous or discontinuous, just press the symbol
[31b] which will change the graphics with the following
meaning:
Once the time has elapsed, you will go to the preservation
phase (next window), where you can change the
cell temperature set point, ,by pressing above the
corresponding values
Non-continuous
Continuous
The cycle is executed only according to the set time,
however if, by any chance, the product has the needle
probe inserted, by pressing the key [31], you can go
from the display of the cell probe to the display of the
needle probe or vice versa.
25
32
26
33
31
27
28
31
31b
At any moment, in order to stop the cycle, press the
key [33]
33
To Next Page
Loading...
