TECO speecon 7200ma - Page 103

101
Parameter
No.
Name
LCD display
(English)
Unit Description
Multi-function
Analog Output Level
Un-13
Amount of PG
Speed Feedback
Un-13= 100.0%
PG Feedback.
0.1%
100.0%=MAX. output
frequency
10V/MAX. Out
p
ut
Frequency
Un-14
Amount of PG
Speed Compen.
Un-14= 100.0%
PG Compen.
0.1% 100.0%=MAX. output freq.
10V/MAX. Out
p
ut
Frequency
Un-15 PID Control Input
Un-15= 100%
PID Input
0.1% 100.0%=MAX. output freq.
10V/Max. output
frequency
Un-16
PID Control
Output 1
Un-16= 100%
PID Output1
0.1% 100.0%=MAX. output freq.
10V/Max. output
frequency
Un-17
PID Control
Output 2
Un-17= 00%
PID Output2
0.1% 100.0%=MAX. output freq.
10V/Max. output
frequency
Un-18 Fault Message 1
Overcurrent
Message1
－ Fault message occurred now －
Un-19 Fault Message 2
Overcurrent
Message2
－
Fault message occurred
last time
－
Un-20 Fault Message 3
Overheat
Message3
－
Fault message occurred
last two time
－
Un-21 Fault Message 4
Overtorque
Message4
－
Fault message occurred
last three time
－
Un-22
The Parameter
Of Time Period
Between Last
Fault And The
Nearest Fault.
Un-22= 2400Hr
Last Fault Run Time
1Hr
The value of ‘Run Elapse
Time’ parameter will be
cleared after fault has been
cleared.
－
Un-23
Frequency
Command While
Fault Occurred
Un-23= 60.00Hz
Last Fault Freq.Cmd.
0.01Hz －－
Un-24
Output Freq.
While Fault Occurred
Un-24= 60.00Hz
Last Fault O/P Freq.
0.01Hz －－
Un-25
Output Current
While Fault Occurred
Un-25= 12.5A
Last Fault O/P I
0.1A －－
Un-26
Output Voltage
While Fault Occurred
Un-26= 220.0V
Last Fault O/P V
0.1V －－
Un-27
DC Volta
g
e
While
Fault Occurred
Un-27= 310.0V
Last Fault O/P V
0.1V －－
Un-28
I/P Terminal
Status While
Fault Occurred
Un-28= 00000000
Last Fault I/P Term.
－
Same as Un-11,
display terminal status
－
Un-29
O/P Terminal
Status While
Fault Occurred
Un-29= 00000000
Last Fault O/P Term.
－
Same as Un-12,
display terminal status
－
Un-30
Time Elapsed
After Power-On
Un-31= 00002Hr
P Elapsed Time
1Hr
Display total time elapsed
after power ON
－
Un-31
Time Elapsed
After Run
Un-31= 00002Hr
R Elapsed Time
1Hr
Display total time elapsed
after pressing RUN
－
Un-32
EPROM S/W
Vers io n
Un-32= 00001
Soft Number
－ -Manufacturing use- －
Un-33
Feedback
Motor Speed
Un-33= 00000r
p
m
Motor Speed
1rpm
Display motor speed while PG
feedback is set.
10V/MAX. Motor
Speed