TECO speecon 7200ma - Parameter Description

31
■ Parameter description
The 7200MA has 4 groups of user parameters:
Parameters Description
An-□□ Frequency command
Bn-□□ Parameter groups can be changed during running
Sn-□□ System parameter groups (can be changes only after stop)
Cn-□□ Control parameter groups (can be changed only after stop)
The parameter setting of Sn-03 (operation status) will determine if the setting
value of different parameter groups are allowed to be changed or only to be
monitored, as shown below:
DRIVE mode PRGM mode
Sn-03
To be set
To be monitored
To be set
To be monitored
0
*1
An,Bn Sn,Cn An,Bn,Sn,Cn －
1 An Bn,(Sn,Cn)
*2
An Bn,Sn,Cn
*1：Factory setting
*2：When in DRIVE mode, the parameter group Sn-, Cn- can only be monitored if
the
RESET
key and the
DSPL
key are to be pressed simultaneously.
After a few trial and adjustment, the setting value Sn-03 is set to be “1” so as not
be modified again.