TECO speecon 7200ma - SINK;SOURCE Typical Connection Diagram

115
E. SINK/SOURCE Typical Connection Diagram
•The UL/CUL standard type control board (Code No. : 4P101C0060002) terminal
c~j can be set as sink or source type input interface, the typical connection
examples shown as below.
(a) SINK type input interface : The short pin of TP2 set to SINK position.
•Transistor (Open-collector) used for operation signal
1 8∼
24VG
TP2
SINK
SOURCE
•NPN sensor (sink) used for operation signal
1 8∼
24VG
24V
NPN
SINK
SOURCE
TP2
(b) SOURCE type input interface : The short pin of TP2 set to SINK position.
•Transistor (Open-collector) used for operation signal
1 8
∼
24V
TP2
SINK
SOURCE
•PNP sensor (source) used for operation signal
1 8∼
24VG
24V
PNP
SINK
SOURCE
TP2