Tektronix 434 - Page 192

Mechanical Parts List— 434/R 434
FIGURE 2 CHASSIS, REAR &
Fig. &
Index Tektronix
No. Part No.
Serial/Model No.
Eff Disc
Q
t
y
2-1 05 ------ --- - -
2
-106 211-0504-00 1
-107 407-0885-00 1
-108 211-0504-00 1
-109 348-0055-00
2
-110 343-0089-00
2
-111 358-0215-00 3
-112 386-1922-00 1
-113 211-0065-00 7
-114 214-1138-00 2
-115 211-0012-00 2
-116 210-0406-00 2
-117 210-0599-00
2
-118 214-0368-00 1
-119 343-0097-00
1
-120 210-0627-00 1
-121 352-0262-00 1
210-0201-00
1
-122 200-0608-00
1
-1 2 3 ...................
1
-124 210-0562-00
1
-125 348-0031-00 1
-126 407-0888-00 1
-127 210-0457-00
2
-128 210-0201-00
1
-129 210-0406-00 1
-130 376-0092-01
1
213-0076-00
2
STANDARD ACCESSORIES (cont)
Description
1 2 3 4 5_______________________________________
COIL
mounting hardware for each: (not included w/coil)
SCREW, 6-32 x 0.25 inch, PHS
BRACKET, coil
mounting hardware: (not included w/bracket)
SCREW, 6-32 x 0.25 inch, PHS
GROMMET, plastic, 0.25 inch
CLAMP, cable, snap-on
BUSHING, plastic
PANEL, rear
mounting hardware: (not included w/panel)
SCREW, 4-40 x 0.188 inch, PHS
HEATSINK, 1 inch diameter
mounting hardware for each: (not included w/heatsink)
SCREW, 4-40 x 0.375 inch, PHS
NUT, hex., 4-40x0.188 inch
NUT, sleeve, 4-40 x 0.391 inch long
SPRING, 0.24 inch diameter
CLAMP, heat sink, plastic
RIVET
HOLDER, transistor, heatsink
LUG, solder, SE #4
COVER, variable resistor, plastic
RESISTOR, variable
mounting hardware: (not included w/resistor]
NUT, hex., 0.25-40x0.312 inch
GROMMET, plastic, 0.156 inch diameter
BRACKET, angle, intensity control
mounting hardware: (not included w/bracket)
NUT, keps, 6-32x0.312 inch
LUG, solder, SE #4
mounting hardware: (not included w/lug)
NUT, hex., 4-40x0.188 inch
COUPLER HALF, shaft
coupler half includes:
SETSCREW, 2-56 x 0.125 inch, HSS
9-12