Tektronix AFG3000 Series - Source[1|2]]:Frequency:start

Syntax and Commands
3-54 AFG3000 Series Arbitrary/Function Generators Reference Manual
[SOURce[1|2]]:FREQuency:STARt
This command sets or queries the start frequency of sweep for the specified
channel. This command is always used with the
[SOURce[1|2]]:FREQuency:STOP command. The setting range of start frequency
depends on the waveform selected for sweep.
Group
Source
Related Commands
[SOURce[1|2]]:FREQuency:MODE
[SOURce[1|2]]:FREQuency:STOP
Syntax
[SOURce[1|2]]:FREQuency:STARt {<frequency>|MINimum|MAXimum}
[SOURce[1|2]]:FREQuency:STARt? {MINimum|MAXimum}
Arguments
<frequency>::=<NRf>[<units>]
where
<NRf> is the start frequency.
<units>::=[Hz | kHz | MHz]
Returns
<frequency>
Examples
SOURce1:FREQuency:STARt 10kHz
sets the sweep start frequency of CH 1 to 10 kHz.