Tektronix AFG3000 Series - Afgcontrol:cscopy (no Query Form); Cal?

Syntax and Commands
3-16 AFG3000 Series Arbitrary/Function Generators Reference Manual
AFGControl:CSCopy (No Query Form)
This command copies setup parameters for one channel to another channel.
If your arbitrary/function generator is a single-channel model, this command is not
supported.
Group
AFG Control
Syntax
AFGControl:CSCopy {CH1|CH2},{CH1|CH2}
Arguments
CH1|CH2
Examples
AFGControl:CSCopy CH1,CH2
copies the CH1 setup parameters into CH2.
*CAL?
This command performs an internal calibration and returns 0 (Pass) or a calibration
error code.
Group
Calibration and Diagnostic
Related Commands
CALibration[:ALL]?
Syntax
*CAL?
Arguments
None
Returns
<NR1>
where
<NR1>=0 indicates that the internal calibration completed without errors.
<NR1>≠0 indicates that the arbitrary/function generator detected an error.
Examples
*CAL?
performs an internal calibration and returns results. For example, it might return 0,
which indicates that the calibration completed without any errors.
NOTE. The self-calibration can take several minutes to complete. During this time,
the arbitrary/function generator does not execute any commands. Do not power off
the instrument during the self-calibration.