Tektronix AFG3000 Series - Source[1|2]]:Fskey:internal:rate; Source[1|2]]:Fskey[:Frequency]

Syntax and Commands
3-56 AFG3000 Series Arbitrary/Function Generators Reference Manual
[SOURce[1|2]]:FSKey[:FREQuency]
This command sets or queries the hop frequency of FSK modulation for the spec-
ified channel.
Group
Source
Syntax
[SOURce[1|2]]:FSKey[:FREQuency] {<frequency>|MINimum|MAXimum}
[SOURce[1|2]]:FSKey[:FREQuency]? {MINimum|MAXimum}
Arguments
<frequency>::=<NRf>[<units>]
where
<NRf> is the hop frequency.
<units>::=[Hz | kHz | MHz]
Returns
<frequency>
Examples
SOURce1:FSKey:FREQuency 1.0MHz
sets the hop frequency of CH 1 FSK modulation to 1.0 MHz.
[SOURce[1|2]]:FSKey:INTernal:RATE
This command sets or queries the internal modulation rate of FSK modulation for
the specified channel. You can use this command only when the internal modula-
tion source is selected.
Group
Source
Syntax
[SOURce[1|2]]:FSKey:INTernal:RATE {<rate>|MINimum|MAXimum}
[SOURce[1|2]]:FSKey:INTernal:RATE?[MINimum|MAXimum]
Arguments
<rate>::=<NRf>[<units>]
where
<NRf> is the modulation rate.
<units>::=[Hz | kHz | MHz]
Returns
<rate>
Examples
SOURce1:FSKey:INTernal:RATE 50Hz
sets the CH 1 internal modulation rate to 50 Hz.