Removal and Installation Procedures
6. Disconnect the
se cables:
NOTE. For Option 02 or 06, there are no cable connections at J600 and J700
on the CH1 OUT10G board.
The cable at J600 from the CH1 OUT10G board to the AWG12G board
(J100A).
The cable at J700 from the CH1 OUT10G board to the AWG12G board
(J101A).
The cable at J100 from the CH1 OUT10G board to the AWG12G board
(J110A).
The cable at J110 from the CH1 OUT10G board to the AWG12G board
(J111A)
.
The cable at J150 from the CH1 OUT10G board to the AWG12G board
(J115A
).
The cable at J170 from the CH1 OUT10G board to the AWG12G board
(J116
A).
The cable at J690 from the CH1 OUT10G board to the Channel 1 Analog
conne
ctor.
The cable at J790 from the CH1 OUT10G board to the Channel 1 Analog
conn
ector.
The cable at J120 from the CH1 OUT10G board to the Channel 1 Mkr
1co
nnector.
The cable at J130 from the CH1 OUT10G board to the Channel 1 Mkr
1c
onnector.
The cable at J160 from the CH1 OUT10G board to the Channel 1 Mkr
2
connector.
The cable at J190 from the CH1 OUT10G board to the Channel 1 Mkr
2 connector.
7. Remove the four screws securing the CH1 O UT10G board to the chassis.
8. Lift the board away from the chassis.
Installation. To install, reverse this procedure.
AWG7000B and AWG7000C Series Service Manual 4–49
To Next Page
Loading...
Need help?
General
