!#) " "&' '#" %#(%&
"'""
6Ć10
"% "&'%('#"&
First read over the Summary of Procedures that follows to underĆ
stand how the procedures are grouped. Then read Equipment
Required for a list of the tools needed to remove and install modules
in this oscilloscope.
Procedures refer to the front," rear," top," and other portions of
the oscilloscope. Figure 6Ć1 illustrates these references.
(% ,+& #&#$ %"''#"
(!!%* # %#(%&
The procedures are described in the order in which they appear in this
section. In addition, you can look up any procedure for removal and reinstalĆ
lation of any module in the Table of Contents of this manual.
To Next Page
Loading...
