& &$&"# '
&$&"# &($#
4Ć6
7. Return the coupling to and press the button.
8. Repeat this procedure until all input channels are verified.
&* ( !($% # )#($#'
1. Install the probe on .
2. Press the button until the readout indicates channel 1
is the only selected channel.
3. Press the button.
4. Press the button, then position the channel 2 trace to the bottom
horizontal graticule line.
5. Press the button, removing the channel 2 display.
6. Press the button and set to #.
7. Verify that a second waveform of approximately 2.6 divisions amplitude
has been added to the display.
8. Set to $%.
9. Set the sec/div scale to 100 ms.
10. Verify that the two waveforms are displayed simultaneously.
11. Set to !(.
12. Verify that the two waveforms are displayed alternately.
13. Set to .
14. Press the button.
&* ( " '
1. Press the button until the readout indicates channel 1
is the only selected channel.
2. Install the probe on .
3. Press the button.
To Next Page
Loading...
