# !! "
# "
6Ć11
"! " Ċ Table 6Ć3 lists the tools required to completely
disassemble the oscilloscope into its modules.
All the tools are standard tools readily available from tool suppliers.
$&% " " #
!
!
1 Screwdriver handle Accepts TorxRĆdriver bits.
2 TĆ15 Torx tip TorxRĆdriver bit for TĆ15 size screw heads.
3 TĆ20 Torx tip TorxRĆdriver bit for TĆ20 size screw heads. Used only for removĆ
al of the cabinet handle.
4 Nut driver, 5/16 inch Used for removing the CRT earth ground cable.
5 AngleĆtip tweezers Used for knob and shaft removal.
6 FlatĆbladed spudger A nonĆmetallic probeĆlike tool with a flat bladed tip. Used to
remove the frontĆpanel trim and front module.
7 SlipĆjaw pliers Used for removing the front feet from the cabinet.
To Next Page
Loading...
