TDS2CMA Communications Module
128
TDS1000/2000-Series Digital Oscilloscope User Manual
CAUTION. Electrostatic discharge (ESD) can damage components in
the module and the oscilloscope. To prevent ESD, follow the next list
of precautions when installing, removing, or handling an module.
After removing a module, install the dummy module cover to protect
the contact pins.
H Always power down the oscilloscope before removing or
installing the module.
H Handle the module as little as possible.
H Transport and store the module in a static-protected bag or
container.
H Do not slide the module over any surface.
H Wear a grounded antistat ic wrist strap to discharge the static
voltage from your body whil e i nstalling or removing a module
from the oscilloscope.
H Do not touch the oscilloscope module connector pins.
H Do not use any devices capable of generating or holding a static
charge in the work area where you install or remove the module.
H Avoid handling the m odule in areas that have a floor or
work-surface c overing capable of generating a static charge.
H Make sure that you insta ll the module cover after you remove the
module.
To Next Page
Loading...
Need help?
General
