Tektronix TDS2024 User Manual

TDS2CMA Communications Module
150
TDS1000/2000-Series Digital Oscilloscope User Manual
Command Entry
When you enter oscilloscope commands over the RS-232 or GPIB
bus, follow these general rules:
H You can enter commands in upper or lower case.
H You can abbreviate many oscilloscope commands. These
abbreviations are shown in uppercase letters. For example, the
command ACQuire:NUMAVg can be entered simply as
ACQ:NUMAV or acq:numav.
H You can precede any command with white space characters.
White space characters include any combination of the ASCII
control characters 00 through 09 and 0B through 20 hexadecimal
(0 through 9 and 11 through 32 decimal).
H The oscilloscope ignores commands that consist of just a
combination of white space characters and line feeds.
Refer to the TDS200-, TDS1000- and TDS2000-Series Digital
Oscilloscope Programmer Manual (071-1075-XX) for more
information.

Tektronix TDS2024 Specifications

General

Channels	4
Bandwidth	200 MHz
Sample Rate	2 GS/s
Record Length	2.5k points
Vertical Resolution	8 bits
Vertical Sensitivity	2 mV/div to 5 V/div
Timebase Range	5 ns/div to 50 s/div
Display Resolution	320 x 240 pixels
Math Functions	Add, Subtract, Multiply, Divide, FFT
Input Coupling	AC, DC, GND
Trigger Modes	Auto, Normal, Single
Trigger Types	Edge, Video, Pulse
Connectivity	USB
Input Impedance	1 MΩ
Maximum Input Voltage	300 V
Interface	USB
Power Supply	100 to 240 V
Dimensions	326 mm x 158 mm x 124 mm