Tektronix TDS2024 User Manual

TDS2CMA Communications Module
TDS1000/2000-Series Digital Oscilloscope User Manual
135
Connecting an External Device
When you connect the module t o an external RS-232 device, follow
these guidelines:
H Use t he c orrect cable (re fer to the table on page 134).
H Use a cable that is no longer than 50 feet.
H Power off the oscilloscope and the external device before you
connect the cable between them.
H Connect the oscilloscope only to a DCE device.
H Check that the oscilloscope signal ground (pin 5) is connected to
the external device signa l ground.
H Connect the chassis ground of the oscilloscope to the chassis
ground of the external de vice.

Tektronix TDS2024 Specifications

General

Channels	4
Bandwidth	200 MHz
Sample Rate	2 GS/s
Record Length	2.5k points
Vertical Resolution	8 bits
Vertical Sensitivity	2 mV/div to 5 V/div
Timebase Range	5 ns/div to 50 s/div
Display Resolution	320 x 240 pixels
Math Functions	Add, Subtract, Multiply, Divide, FFT
Input Coupling	AC, DC, GND
Trigger Modes	Auto, Normal, Single
Trigger Types	Edge, Video, Pulse
Connectivity	USB
Input Impedance	1 MΩ
Maximum Input Voltage	300 V
Interface	USB
Power Supply	100 to 240 V
Dimensions	326 mm x 158 mm x 124 mm