Tektronix TDS3000C Series - Page 145

Appendix A: Specifications
This appendix contains specifications for the TDS3000C Series oscilloscopes. All
specifications are guaranteed unless noted as "typical." Typical specifications
are provided
for your convenience but are not guaranteed. Specifications
that are marked with the
symbol are checked in the TDS3000C
Specifications and Performance Verification Technical Reference available o n the
www.tektronix.com/manuals Web site.
All specifications apply to all TDS3000C Series models unless noted otherwise.
To meet specifications, two conditions must first be met:
The oscilloscope must have been operating continuously for twenty minutes
within the operating temperature range specified.
You must perform the Signal Path Compensation operation. (See page 4,
Signal Path Compensation (SPC).) If the operating temperature changes by
more than 10 °C (18 °F), you must perform the Signal Path Compensation
operation again.
Acquisition
Acquisition
modes
Sample (Normal), Peak detect, En velope, and Average
Acquisition mode
Acquisition stops after
Sample, Peak Detect One acquisition, all channels
simultaneously
Single
Sequence
Average, Envelope N acquisitions, all channels
simultaneously, N is settable from
2 to 256 (or ∞ for Envelope)
TDS3000C Series Oscilloscope User Manual 121