Getting Started
Installing the Battery
To install the o
ptional battery pack, follow these steps:
1. Open the battery compartment door on the rear panel.
2. Remove the accessory tray.
Battery door (opened)
3. Slide the battery into the compartment and press it in from both sides until
you hear
the latches click.
4. Press on both sides of the battery compartment door to snap it closed.
To remove the battery, follow these steps:
1. Open the battery compartment door.
2. Raise the handles on each side of the battery and use them to pull the battery
out of the oscilloscope.
TDS3000C Series Oscilloscope User Manual 11
To Next Page
Loading...
