FN990
Family Hardware Design Guide
1VV0301752 Rev. 3 Page 74 of 92 2022-10-07
Not Sub
ect to NDA
This equipment has been tested and found to comply with the limits for a Class B digital
device, according to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used per the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by taking one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Information for the OEMs and Integrators
The following statement must be included with all versions of this document supplied to
an OEM or integrator but should not be distributed to the end user.
1. This device is intended for OEM integrators only.
2. Please see the full Grant of Equipment document for other restrictions
Manual Information to the End User
The OEM integrator should be aware not to provide information to the end user on how to
install or remove this RF module in the user’s manual of the end product which integrates
this module. The end user manual shall include all required regulatory
information/warming as shown in this manual
Information on test modes and additional testing requirement
The module has been evaluated in mobile stand-alone conditions. For operational
conditions other than a stand-alone modular transmitter in a host (multiple,
simultaneously transmitting modules or other transmitters in a host), additional testing
may be required (collocation, retesting…). If this module is intended for use in a portable
device, you are responsible for separate approval to satisfy the SAR requirements of FCC
Part 2.1093.
Additional testing, Part 15 Subpart B disclaimer
The modular transmitter is only authorized by the FCC for the specific rule parts (for
example, FCC transmitter rules) listed on the grant, and that the host product
manufacturer is responsible for compliance to any other FCC rules that apply to the host
To Next Page
Loading...
Need help?
General