EasyManuals Logo

Telit Wireless Solutions FN990 Series User Manual

Telit Wireless Solutions FN990 Series
92 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #80 background imageLoading...
Page #80 background image
FN990
Family Hardware Design Guide
1VV0301752 Rev. 3 Page 80 of 92 2022-10-07
Not Sub
j
ect to NDA
Gain maximum pour ISED (dBi)
/ Gain maximum pour ISDE (dBi)
NR
Max Gain to meet IC
ERP/EIRP and MPE limit
Max Gain to consider EN-DC
Active
Max gain allowed
n66 5.5 5.5 5.5
n71 6.0 2.9 2.9
n77 0.5 0.5 0.5
n78 0.5 0.5 0.5
Table 58: Max antenna gain for ISED in dBi / Gain d'antenne max pour ISED en dBi
– NR bands
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
L'émetteur ne doit pas être colocalisé ni fonctionner conjointement avec à autre antenne
ou autre émetteur.
This equipment must be installed and operated in accordance with provided instructions
and the antenna(s) used for this transmitter must be installed to provide a separation
distance of at least 20 cm from all persons and must not be co-located or operating in
conjunction with any other antenna or transmitter. End-users and installers must be
provided with antenna installation instructions and consider removing the no-collocation
statement.
Cet équipement doit être installé et utilisé conformément aux instructions fournies et la
ou les antennes utilisées pour cet émetteur doivent être installées pour fournir une
distance de séparation d'au moins 20 cm de toutes les personnes et ne doivent pas être
co-localisées ou fonctionner en conjonction avec toute autre antenne ou émetteur. Les
utilisateurs finaux et les installateurs doivent recevoir les instructions d'installation de
l'antenne et envisager de supprimer la déclaration de non-collocation.
Information on test modes and additional testing requirement /
Informations sur les
modes de test et exigences de test supplémentaires
The module has been evaluated in mobile stand-alone conditions. For operational
conditions other than a stand-alone modular transmitter in a host (multiple,
simultaneously transmitting modules or other transmitters in a host), additional testing
may be required (collocation, retesting…) If this module is intended for use in a portable
device, you are responsible for separate approval to satisfy the SAR requirements IC RSS-
102.

Table of Contents

Other manuals for Telit Wireless Solutions FN990 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Telit Wireless Solutions FN990 Series and is the answer not in the manual?

Telit Wireless Solutions FN990 Series Specifications

General IconGeneral
BrandTelit Wireless Solutions
ModelFN990 Series
CategoryComputer Hardware
LanguageEnglish