58
Tempest900 2-Channel Operating Manual
When an external 2-Wire hard wired intercom system IS present:
Set the 2-Wire Intercom Type Select Switch to the proper type and select 2-Wire mode. Connect the hard wired intercom to the BaseStation. In
this conguration, each connected Tempest BaseStation intercom channel will receive power and termination from the wired intercom system.
The Tempest BaseStation functions as an additional wired BeltStation from the perspective of the connected 2-Wire system.
Connect either male or female (male and female connectors are electrically identical) 3 pin XLR from the 2-Wire intercom channel to be shared,
to the BaseStation that will use the intercom channel. Loop to other BaseStations as needed. Repeat for all channels to be shared. See the Wired
Intercom Interface section in this manual for more information about connecting to external wired intercom systems.
When using an external 2-Wire hard wired connection, only channels that are connected to a wired
intercom will be able to share audio between BaseStations.
To Next Page
Loading...
