29
Automatically Obtaining an IP Address
This mode enables the AP to automatically obtain an IP address, a subnet mask, a gateway IP address, DNS
server IP addresses from a DHCP server on your LAN. If a large number of APs are deployed, you can adopt this
mode to avoid IP address conflicts and effectively reduce your workload.
Configuration procedure:
Step 1 Choose Network Settings > LAN Setup.
Step 2 Set Address Mode to DHCP.
Step 3 Click Save.
---End
After the configuration, if you want to log in to the web UI of the AP again, check the client list of the
DHCP server for the IP address assigned to the AP, ensure that the IP address of the management
computer and the IP address of the AP belong to the same network segment, and access the IP address of
the AP.
To Next Page
Loading...
Need help?
General
