91
Step 3 Set parameters as follows:
Set Log Server IP Address to the IP address of the log server.
Set Log Server Port to the UDP port number used to send and receive system logs. The default
port number 514 is recommended.
Select Enable to enable the log server.
Step 4 Click Save.
---End
The following figure shows the configuration.
Procedure for changing log server settings
Step 1 To access the page, choose Tools > Logs and click Log Settings.
Step 2 Click Edit corresponding to the log server settings to be changed.
Step 3 Change the parameter settings as required.
Step 4 Click Save.
c
To Next Page
Loading...
