Tenda AX3000 User Manual

55
Parameter description
Parameter Description
QVLAN It specifies whether to enable the QVLAN function of the AP.
PVID It specifies the ID of the default native VLAN of the trunk port of the AP.
Management VLAN
It specifies the ID of the AP management VLAN.
After changing the management VLAN, you can manage the AP only after connecting
your computer or AP controller to the new management VLAN.
Trunk Port
Choose the port which to be set as the trunk mode. By default, LAN0 is chosen. Trunk
port allows data of all VLANs to pass.
When you enable the 802.1Q VLAN function, choose at least one LAN port as the trunk
port. If the AP has only one Ethernet port, this port serves as the trunk port by default.
LAN0 Port VLAN ID
It specifies the Ethernet port of the AP and the ID of the VLAN to which a LAN port
belongs.

LAN0: The PoE power and data transmission multi-functional port of the AP.

LAN1: The data transmission port of the AP.
Ethernet port not set as the trunk port is seen as the access port and you can set its
VLAN ID.
LAN1 Port VLAN ID
2.4 GHz SSID It specifies the currently enabled SSID(s) over the 2.4 GHz/5 GHz band of the AP, and
the VLAN IDs corresponding to SSIDs.
After the QVLAN function is enabled, the wireless ports corresponding to SSIDs
functions as access ports. The PVID of an access port is the same as its VLAN ID.
5 GHz SSID
VLAN ID

Tenda AX3000 Specifications

General

Wi-Fi Standard	Wi-Fi 6 (802.11ax)
MU-MIMO	Yes
Beamforming	Yes
OFDMA	Yes
Frequency Bands	2.4 GHz, 5 GHz
Ports	1 x 10/100/1000 Mbps WAN port, 3 x 10/100/1000 Mbps LAN ports
Antenna	4 x external antennas
Security	WPA3, WPA2, WPA, WEP
Button	WPS/Reset