Tenda AX3000 User Manual

51
6.5 Access control
6.5.1 Overview
The access control function enables you to allow or disallow the wireless devices to access the
wireless network of the AP based on their MAC addresses.
The AP supports the following 2 filter modes:
 Forbid only: It indicates that only the wireless devices with the specified MAC addresses cannot
access the wireless networks of the AP.
 Permit only: It indicates that only the wireless devices with the specified MAC addresses can
access the wireless networks of the AP.
Access Control is disabled by default. The following figure displays the page when Access Control is
enabled.

Tenda AX3000 Specifications

General

Wi-Fi Standard	Wi-Fi 6 (802.11ax)
MU-MIMO	Yes
Beamforming	Yes
OFDMA	Yes
Frequency Bands	2.4 GHz, 5 GHz
Ports	1 x 10/100/1000 Mbps WAN port, 3 x 10/100/1000 Mbps LAN ports
Antenna	4 x external antennas
Security	WPA3, WPA2, WPA, WEP
Button	WPS/Reset