Document version: V1.0
31
Example of setting up a wireless network encrypted with WPA or WPA2
Networking requirement
A highly secure wireless network is required and a RADIUS server is available. In this case, WPA or
WPA2 mode is recommended.
Assume that the IP address of the RADIUS server is 192.168.0.200, the RADIUS password is
UmXmL9UK, the port number for authentication is 1812, and the SSID is hot_spot. See the
following figure.
Configuration procedure
Configure the AP.
Assume that the first SSID of the 2.4 GHz radio band of the AP is to be configured. WPA2 and AES
are used here for illustration.
Step 1 Choose Wireless > SSID.
Step 2 Select the first SSID from the SSID drop-down list menu
Step 3 Set Status to Enable.
Step 4 Change the value of the SSID text box to hot_spot.
To Next Page
Loading...
