Tenda i27 User Manual

Document version: V1.0
88
8.4 System Log
The logs of the AP record various events that occur and the operations that users perform after the
AP starts. In case of a system fault, you can refer to the logs during troubleshooting.
The Logs page allows you to view system logs.
To access the page, choose Tools > System Log > Logs.
To ensure that the logs are recorded correctly, verify that the system time of the AP is correct. You
can correct the system time of the AP by choosing Tools > Date & Time > System Time.
By default, AP saves the latest 150 logs. The earlier logs will be automatically deleted if more than
150 logs are generated. To view the latest logs of the AP, click Refresh. To clear the existing logs of
the AP, click Clear.
⚫
When the AP reboots, the previous logs are lost.
⚫
The AP reboots when the AP is powered on after a power failure, the QVLAN function is configured,
the firmware is upgraded, an AP configuration is restored, or the factory settings are restored.

Tenda i27 Specifications

General

Antenna type	External
Antennas quantity	2
Antenna gain level (max)	4 dBi
2.4 GHz	Yes
MIMO type	Multi User MIMO
Number of users	254 user(s)
Networking standards	IEEE 802.11a, IEEE 802.11ac, IEEE 802.11ax, IEEE 802.11b, IEEE 802.11g, IEEE 802.11k, IEEE 802.11n, IEEE 802.11v, IEEE 802.3at
Virtual LAN features	Tagged VLAN
Spread spectrum method	OFDMA
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Maximum data transfer rate	2976 Mbit/s
Maximum data transfer rate (5 GHz)	2402 Mbit/s
Maximum data transfer rate (2.4 GHz)	574 Mbit/s
Power consumption (max)	14.04 W
Placement	Ceiling, Wall
Product color	White
Security algorithms	SSID, WEP, WPA, WPA-PSK, WPA2, WPA2-PSK
Number of SSID supported	8
Service Set Identifier (SSID) features	Hidden SSID
Storage temperature (T-T)	-30 - 70 °C
Operating temperature (T-T)	-10 - 45 °C
Operating relative humidity (H-H)	10 - 90 %
USB 2.0 ports quantity	-
Ethernet LAN (RJ-45) ports	1

Weight and Dimensions

Depth	38 mm
Width	178 mm