Tenda i27 User Manual

Document version: V1.0
80
8.2.2 Reset
If you cannot locate a fault of the AP or forget the password of the web UI of the AP, you can reset
the AP to restore its factory settings and then configure it again.
⚫
When the factory settings are restored, your configuration is lost. Therefore, you need to
reconfigure the AP to reconnect to the internet. Restore the factory settings of the AP only when
necessary.
⚫
To prevent AP damages, ensure that the power supply of the AP is normal when the AP is reset.
⚫
After the factory settings are restored, the login IP address of the AP is changed to 192.168.0.254,
and the user name and password of the AP are changed to admin.
Method 1:
After AP completes startup, hold down the RESET button for about 8 seconds.
Method 2:
Log in to the web UI of the AP, on the Tools > Maintenance > Maintenance page, click Reset.

Tenda i27 Specifications

General

Antenna type	External
Antennas quantity	2
Antenna gain level (max)	4 dBi
2.4 GHz	Yes
MIMO type	Multi User MIMO
Number of users	254 user(s)
Networking standards	IEEE 802.11a, IEEE 802.11ac, IEEE 802.11ax, IEEE 802.11b, IEEE 802.11g, IEEE 802.11k, IEEE 802.11n, IEEE 802.11v, IEEE 802.3at
Virtual LAN features	Tagged VLAN
Spread spectrum method	OFDMA
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Maximum data transfer rate	2976 Mbit/s
Maximum data transfer rate (5 GHz)	2402 Mbit/s
Maximum data transfer rate (2.4 GHz)	574 Mbit/s
Power consumption (max)	14.04 W
Placement	Ceiling, Wall
Product color	White
Security algorithms	SSID, WEP, WPA, WPA-PSK, WPA2, WPA2-PSK
Number of SSID supported	8
Service Set Identifier (SSID) features	Hidden SSID
Storage temperature (T-T)	-30 - 70 °C
Operating temperature (T-T)	-10 - 45 °C
Operating relative humidity (H-H)	10 - 90 %
USB 2.0 ports quantity	-
Ethernet LAN (RJ-45) ports	1

Weight and Dimensions

Depth	38 mm
Width	178 mm