Document version: V1.0
61
6.6 Access control
6.6.1 Overview
The access control function enables you to allow or disallow the wireless devices to access the
wireless network of the AP based on their MAC addresses.
To access the page, choose Wireless > Access Control.
The AP supports the following 2 filter modes:
−
Blacklist: It indicates that only the wireless devices with the specified MAC addresses
cannot access the wireless networks of the AP.
−
Whitelist: It indicates that only the wireless devices with the specified MAC addresses
can access the wireless networks of the AP.
Access Control is disabled by default.
To Next Page
Loading...
