Tenda i27 - Configure Uplink Detection

Document version: V1.0
91
8.6.2 Configure uplink detection
Step 1 Choose Tools > Uplink Detection.
Step 2 Enable Uplink Detection.
Step 3 Enter the IP address of the host to be pinged in Host1 to Ping or Host2 to Ping, such as the
IP address of the switch or router directly connected to the Ethernet port of the AP. If there
is only one host IP address, enter this IP address in both Host1 to Ping and Host2 to Ping.
Step 4 Set Ping Interval to the interval at which the AP detects its uplink. The default value is 10
minutes.
Step 5 Click Save.
----End
Parameter description
Parameter
Description
Uplink Detection
It specifies whether to enable the Uplink Detection function of the AP.
Host1 to Ping
Enter the IP address of the host to be pinged. This parameter can be set if Uplink
Detection is enabled.
Host2 to Ping
Ping Interval
Set the interval at which this device detects the uplink. This parameter can be set if
Uplink Detection is enabled.