Tenda i27 - Configure Access Control

Document version: V1.0
62
Parameter description
Parameter
Description
SSID
It specifies the wireless network to which the rule applies.
Access Control
It specifies whether to enable this function.
Mode
Set access control mode.
⚫
Blacklist: It indicates that only the wireless clients on the wireless access control list
cannot connect to the AP with the selected SSID.
⚫
Whitelist: It indicates that only the wireless clients on the wireless access control
list can connect to the AP with the selected SSID.
MAC Address
It specifies the MAC address of client.
Add
Manually add the device with the MAC address you specified to the access control list.
Add Online Devices
Add the online wireless clients to the access control list conveniently.
Status
It specifies the status of the rule. You can enable or disable it as required.
Operation
Click to delete the rule.
6.6.2 Configure access control
Step 1 Choose Wireless > Access Control. Choose a wireless network radio band on which access
control is to be configured.
Step 2 Select the SSID to which the access control is applied from the SSID drop-down list menu.
Step 3 Enable Access Control.
Step 4 Set Mode to Blacklist or Whitelist.
Step 5 Enter the MAC address of the wireless device to which the rule applies. Then click Add.
If the wireless device to be controlled has connected to the AP, click Add Online Devices to quickly add
the MAC address of the device to the access control client list.
Step 6 Click Save.
----End