PW201A Wireless N Powerline AP User Guide
69
1. Press the Pair button on PW201A-2 for 1-3 seconds and then
release it. When the PLC LED on the PW201A-2 starts blinking, it indicates
this PW201A-2 is searching for available networks.
2. Within 2 minutes upon releasing PW201A-2’s Pair button, press the
Pair button on either P200 or PW201A-1 to start pairing.
3. Observe all Powerline device’s LED status. When the Power LED
displays a solid light and the PLC LED concurrently blinks rapidly, it
indicates the PW201A-2 has been successfully connected to the existing
Network 1.
To disconnect a Powerline device from the existing Powerline network,
do as follows:
As mentioned above, one P200 and two PW201A devices have
interconnected on a private Powerline network. If you want to disconnect
PW201A-1 from the network, press the Pair button on PW201A-1 for over 6
seconds and then release it. When the Power LED on the PW201A-1 goes
off, it indicates the PW201A-1 has left Network 1.
To Next Page
Loading...
