Working operation of the machine 5
TW85 59
5.4.5 Using the machine for crane operations
Earth moving equipment may only be
operated in the context of using lifting
gear if it is equipped and approved for
such work.
Note the maximum permissible load of
2.5 t for the load hook.
• When using the machine for crane operations,
the safety notes (section 2.16) must be
observed.
• Loads may only be fastened which do not
exceed the lifting capacities of the machine
and the lifting gear (section 3.14)
Overload warning device
When overloaded, an optical display and
an acoustic signal will issue a warning.
This does not avert the risk of turning
over.
The integrated overload warning device cannot
entirely exclude accidents as a consequence of
incorrect operation.
This applies in particular for:
• Bottom hook of the load or lifting gear
• Excessive delay or acceleration forces (hard
braking or a strong start to the slewing action
with the load being moved)
• A load falling against the cable
• Pulling up at an angle
• Moving the earth moving equipment to an area
where the ground slopes more
• Wind load
Avoid these hazards by using the machine
cautiously and prudently.
Working with lifting gear
• The overload warning device (43/54) must be
switched on when the machine is used for
crane operations. The overload warning
indicator (43/40) must be observed.
When the warning signal (continuous buzzing
noise) sounds, you must:
• immediately set down the load
• reduce the reach and/or
• reduce the load.
0
4/4
,
!
P
HM32-043
40
54
Fig. 43 Operation
To Next Page
Loading...
