Chapter 4 ā Communications
TestEquity F4T Controller Page 49
:SOURce:CLOop#:RSCAle HOURS - Set the ramp time units to hours for a control loop
Example :SOURCE:CLOOP1:RSCALE HOURS (set the ramp time units to hours for chamber
temperature)
:OUTPut#:STATe? - Query the state of an Event Output where # is the output number (1-7)
Example :OUTPUT1:STATE? (query the state of Event Output 1)
:OUTPut#:STATe OFF - Set the Event Output off where # is the output number (1-7)
Example :OUTPUT1:STATE OFF (set Event Output 1 to OFF)
:OUTPut#:STATe ON - Set the event output on where # is the output number (1-7)
Example :OUTPUT1:STATE ON (set Event Output 1 to ON)
:PROGram:SELected:NUMBer <numeric value> - Set the current profile number
Example :PROGRAM:SELECTED:NUMBER 1 (set the current profile to profile number 1)
:PROGram:SELected:NAME? - Query the current profile name
:PROGram:SELected:STEP <numeric value> - Set the current profile step
Example :PROGRAM:SELECTED:STEP 1 (set the current profile step to step number 1)
:PROGram:SELected:STATe STArt - Start the current profile
:PROGram:SELected:STATe PAUSe - Pause the current profile
:PROGram:SELected:STATe RESume - Resume the current profile
:PROGram:SELected:STATe STOP - Terminate the current profile
To Next Page
Loading...