Chapter 7: Tables 116
Setting Up the Table
TABLE SETUP Screen
To display the TABLE SETUP screen, press y -.
TblStart, @Tbl
TblStart (table start) defines the initial value for the independent variable. TblStart applies only
when the independent variable is generated automatically (when
Indpnt: Auto is selected).
@
Tbl (table step) defines the increment for the independent variable.
Indpnt: Auto, Indpnt: Ask, Depend: Auto, Depend: Ask
Selections Table Characteristics
Indpnt: Auto
Depend: Auto
Values are displayed automatically in both the independent-
variable column and in all dependent-variable columns.
Indpnt: Ask
Depend: Auto
The table is empty. When you enter a value for the independent
variable, all corresponding dependent-variable values are
calculated and displayed automatically.
Indpnt: Auto
Depend: Ask
Values are displayed automatically for the independent variable.
To generate a value for a dependent variable, move the cursor to
that cell and press Í.
Indpnt: Ask
Depend: Ask
The table is empty; enter values for the independent variable. To
generate a value for a dependent variable, move the cursor to
that cell and press Í.
Setting Up the Table from the Home Screen or a Program
To store a value to
TblStart, @Tbl, or Tbl[nput from the home screen or a program, select the
variable name from the
VARS TABLE secondary menu. TblZnput is a list of independent-variable
values in the current table.
When you press y - in the program editor, you can select
IndpntAuto, IndpntAsk,
DependAuto, and DependAsk.
To Next Page
Loading...
Need help?
General
