Texas Instruments TI-84 PLUS - Graphing Calculator - Recalling Graph Databases (GDB)

Chapter 8: Draw Instructions 136
1. Select 3:StoreGDB from the DRAW STO menu. StoreGDB is pasted to the current cursor
location.
2. Enter the number (from 1 to 9, or 0) of the GDB variable to which you want to store the graph
database. For example, if you enter 7, the TI-84 Plus will store the
GDB to GDB7.
Note: You also can select a variable from the GDB secondary menu ( 3). The variable is
pasted next to
StoreGDB.
3. Press Í to store the current database to the specified GDB variable.
Recalling Graph Databases (GDB)
Recalling a Graph Database
CAUTION: When you recall a GDB, it replaces all existing Y= functions. Consider storing the
current Y= functions to another database before recalling a stored GDB.
To recall a graph database, follow these steps.
1. Select 4:RecallGDB from the DRAW STO menu. RecallGDB is pasted to the current cursor
location.
2. Enter the number (from 1 to 9, or 0) of the GDB variable from which you want to recall a GDB.
For example, if you enter 7, the TI-84 Plus will recall the
GDB stored to GDB7.
Note: You also can select a variable from the GDB secondary menu ( 3). The variable is
pasted next to
RecallGDB.
3. Press Í to replace the current GDB with the recalled GDB. The new graph is not plotted.
The TI-84 Plus changes the graphing mode automatically, if necessary.
Deleting a Graph Database
To delete a GDB from memory, use the
MEMORY MANAGEMENT/DELETE secondary menu
(Chapter 18).