Chapter 19: Communication Link 350
3. Press y 8 on the sending TI-84 Plus to display the LINK SEND menu.
4. Select the menu of the items you want to transmit.
5. Press ~ on the sending TI-84 Plus to display the LINK TRANSMIT menu.
6. Confirm that the receiving unit is set to receive.
7. Press Í on the sending TI-84 Plus to select 1:Transmit and begin transmitting.
Receiving Items
LINK RECEIVE Menu
To display the
LINK RECEIVE menu, press y 8 ~.
Receiving Unit
When you select
1:Receive from the LINK RECEIVE menu on the receiving unit, the message
Waiting... and the busy indicator are displayed. The receiving unit is ready to receive transmitted
items. To exit the receive mode without receiving items, press É, and then select
1:Quit from the
Error in Xmit menu.
When transmission is complete, the unit exits the receive mode. You can select
1:Receive again to
receive more items. The receiving unit then displays a list of items received. Press y 5 to exit
the receive mode.
DuplicateName Menu
During transmission, if a variable name is duplicated, the
DuplicateName menu is displayed on the
receiving unit.
When you select
1:Rename, the Name= prompt is displayed, and alpha-lock is on. Enter a new
variable name, and then press Í. Transmission resumes.
When you select
2:Overwrite, the sending unit’s data overwrites the existing data stored on the
receiving unit. Transmission resumes.
SEND RECEIVE
1: Receive
Sets unit to receive data transmission.
DuplicateName
1: Rename
Prompts to rename receiving variable.
2: Overwrite
Overwrites data in receiving variable.
3: Omit
Skips transmission of sending variable.
4: Quit
Stops transmission at duplicate variable.
To Next Page
Loading...
Need help?
General
