Chapter 19: Communication Link 348
2. Select the menu item that describes the data type to send. The corresponding SELECT screen
is displayed.
3. Press } and † to move the selection cursor ( 4 ) to an item you want to select or deselect.
4. Press Í to select or deselect the item. Selected names are marked with a 0.
Note: An asterisk (ä) to the left of an item indicates the item is archived.
5. Repeat steps 3 and 4 to select or deselect additional items.
Sending the Selected Items
After you have selected items to send on the sending unit and set the receiving unit to receive,
follow these steps to transmit the items. To set the receiving unit, see Receiving Items.
1. Press ~ on the sending unit to display the TRANSMIT menu.
2. Confirm that Waiting... is displayed on the receiving unit, which indicates it is set to receive.
3. Press Í to select 1:Transmit. The name and type of each item are displayed line-by-line
on the sending unit as the item is queued for transmission, and then on the receiving unit as
each item is accepted.
Note: Items sent from the RAM of the sending unit are transmitted to the RAM of the receiving
unit. Items sent from user data archive (flash) of the sending unit are transmitted to user data
archive (flash) of the receiving unit.
After all selected items have been transmitted, the message Done is displayed on both calculators.
Press } and † to scroll through the names.
Sending to a TI-84 Plus Silver Edition or TI-84 Plus
You can transfer variables (all types), programs, and Flash applications to another TI-84 Plus
Silver Edition or TI-84 Plus. You can also backup the RAM memory of one unit to another.
Note: Keep in mind that the TI-84 Plus has less Flash memory than the TI-84 Plus Silver Edition.
To Next Page
Loading...
Need help?
General
