Programming the Control Panel Premier 412/816/832 Installation Manual
22 INS159-13
4. Programming the Control Panel
Introduction
All engineers should read this section carefully so as to familiarise
themselves with the programming of the control panel.
The programming menus can only be accessed when the control
panel is fully disarmed. Enter the default Engineer code
and press followed by to access
the program menus:
A programming menu is selected by entering a two-digit menu
code. On completion of each menu option, the system reverts to the
main programming menu, allowing other programming menu
options to be accessed.
To exit the programming menu enter or press the
key, the system will revert to normal operation:
If the “EN 50131-1 Requirements” option is programmed as
enabled (see page 37) the Engineer code will only be
accepted after a user has authorised Engineer access. For
information on complying with EN 50131-1 please refer to
page 79.
Viewing Numeric Data (LED Keypads)
When programming numeric data, the value of the data may be
viewed by pressing the key. The keypad will flash the value in
sequence using the following lights:
Alarm = 0 Zone 5 = 5
Zone 1 = 1 Zone 6 = 6
Zone 2 = 2 Zone 7 = 7
Zone 3 = 3 Zone 8 = 8
Zone 4 = 4 Armed = 9
Programming Text (LCD Only)
Text is programmed in a similar way to mobile phones. Characters
are selected by pressing the corresponding key the appropriate
number of times (to select a character on the same key, press
to move the cursor along).
The table below shows the keys to use and the characters that are
assigned to them:
To Next Page
Loading...
