Operating the Alarm System Premier 412/816/832 Installation Manual
76 INS159-13
View Service Faults
Standing faults can be viewed as follows:
1. Press the key followed by the key.
The keypad will display any Service Faults (see tables).
On completion press the key.
Service Faults Displayed on LED Keypads
General Warnings
Press (Key 1) to view the warning, lights 1-5 will indicate the
following:-
1 = AC Fail
2 = Arming Fob has Low Battery
3 = Soak Test Active
Box Tamper & Auxiliary Input:
Press to view type, lights 1 - 8 indicate:
1 = Box Tamper 4 = Auxiliary Tamper *
2 = Auxiliary Tamper 5 = Bell Tamper *
3 = Auxiliary PA 6 = Radio Plus Tamper
7 = Low Fob Battery 8 = User Code Tamper
* = UK Bell Module
Zone Tamper/Trouble
Press to view zone number
Keypad Tamper/Removed
Press to view keypad number
Equipment Faults
Press to view fault type, lights 1 - 8 indicate:
1 = Output 1 Fault
2 = Output 2 Fault
3 = Siren/Bell Fault
4 = 2-Wire Smoke Sensor Fault
5 = Auxiliary Fuse Failed
6 = Battery Fault
7 = Service Timer/Zone Soak Test Failed
8 = Com1 Fault or Fail To Communicate
Service Faults Displayed on LCD Keypads
One or more zones on soak test
1 to continue arming 0 to exit arming
Key fob has a low battery (Message above
shown)
Shown after invalid user code attempts
Auxiliary Tamper (Aux Input)
Auxiliary Tamper (UK Bell Module)
Bell Tamper (UK Bell Module)
2-Wire Smoke Sensor Fault
Service Timer/Zone Soak Test Failed
Com1 Fault or Fail To Communicate