Texecom Premier 412 - User Records

Premier 412/816/832 Installation Manual Programming the Control Panel
INS159-13 23
V16 Start up Procedure
V16 sees a new start-up procedure allowing selection of the control panel language, loading specific country defaults and confirming devices
connected to the panel network at start-up.
Premier RKP8 & 16 LED Keypads
For LED keypads there is no change to the current operation. Bypassing the requirement to set the language and country code at initial power
up is as follows.
 Power up the panel
 Enter the default engineers code 
 Press  then 9
You are now in the programming menu and can continue as you did with previous versions of the panel.
Premier LCD Keypads
As with LED keypad operation, the requirement to set the language and country code can be bypassed. The procedure is identical to that
shown for LED keypads.
On powering up the panel the following sequence will be presented. You can exit this procedure at anytime by using the keys detailed in the
Options column.
Action
Display
Options
Enter the default engineers code

et anguage?
E to eet
Press  takes you to the Arming Menu
Press  takes you to the Confirm Devices Menu
Press  takes you to the Confirm Devices Menu
Press  and use the  key to select
the desired language
anguage
Engi
Press  takes you to the Confirm Devices Menu
Press  takes you to the Confirm Devices Menu
Press  takes you to the Confirm Devices Menu
Press  to confirm Language
et Countr?
E to eet
Press  takes you to the Arming Menu
Press  takes you to the Confirm Devices Menu
Press  takes you to the Confirm Devices Menu
Press  and use the numeric keys to
enter the desired country code.
Countr Code
Enter aue: 027
Press  takes you to the Confirm Devices Menu
Press  takes you to the Confirm Devices Menu
The panel will now load the defaults for
the country code selected.
Conirm eie
E to eet
Press  takes you to the Arming Menu
Press  takes you to the Programming Menu
Press  takes you to the Programming Menu
Press  and check that all devices
installed are shown.
et P>1.....
et E>...
Press  takes you to day mode. You will be prompted
to confirm devices when you log in again.
Press .
Conirm eie
E to Conirm
Press  takes you to day mode. You will be prompted
to confirm devices when you log in again.
Press .
Program ime
E to eet
Press  takes you to the Arming Menu
Press  takes you to the Arming Menu
Press  and use the numeric keys to
enter the correct time.
Program ime
> 00:17
Press  takes you to the Programming Menu
Press  takes you to the Programming Menu
You will be prompted to programme the
correct date
Program ate
E to eet
Press  takes you to the Arming Menu
Press  takes you to the Arming Menu
Press  and use the numeric keys to
enter the correct date.
Program ate
> 18/05/15
Press  takes you to the Programming Menu
Press  takes you to the Programming Menu
You are now at the Programming Menu
Programming Menu
Enter Code > ??
Press  takes you to day mode
Press  takes you to day mode
 If confirm devices is not carried out you will be prompted every time you login as an engineer to carry out this function. If the date &
time are not set then the engineer or user will be prompted when they login, and each time until the date and time are set.