Premier 412/816/832 Installation Manual Operating the Alarm System
INS159-13 71
Cancelling the Arming Process
To cancel the arming process during the exit delay:
Premier 816
17:30.21 28/04
MEU or Otion
O to iarm?
d
????
b@
e
b@
e
If the system only has one partition you will not have to
perform step 2.
Disarming During Entry
To disarm the alarm system during entry, proceed as
follows:
Premier 816
08:31.12 28/04
Enter our Code
08:30.59 28/04
????
b@
e
b@
e
If a valid Access code is not entered before the end of the
entry delay, an alarm will occur.
Disarming when not in Entry
To disarm the alarm system when not in entry, proceed
as follows:
Premier 816
17:30.21 28/04
MEU or Otion
O to iarm?
d
????
b@
e
b@
e
If the system only has one partition you will not have to
perform step 2.
If the Quick Disarm feature is enabled (see page 42) and the
system is Stay armed you can omit step 1 from the above
procedure.
Disarming after an Alarm
To disarm the alarm system after an alarm, proceed as
follows:
Zone 05 Atie
Mater Bedroom
Mater Bedroom
1... 21:10.56 28
????
b@
e
The system must now be reset before you can arm again, see page
75 for details on resetting alarms.
Auto Stay Arming
If your installer has enabled the Auto Stay feature the system will
automatically Stay arm if the entry/exit zone (front door) is not
activated whilst attempting to Away arm the system.
To auto Stay arm your alarm system proceed as follows:
Peae Eit....
17:30.21 28/04
E to Arm?
MEU or Otion
????
Changing between Delayed and Instant Stay
When Stay arming the system the delayed zones (front door etc) are
normally delayed, i.e., when a delayed zone is violated it will start
the entry delay timer. However, it is possible to change the delayed
zones to instant when the system is in a Stay armed mode. If a
delayed zone is violated when the system is in the “Instant Stay”
mode the system will generate an alarm immediately.
To change from Delayed Stay to Instant Stay, proceed
as follows:
IA A
17:30.21 28/04
s
b@
e
To Next Page
Loading...
