Programming the Control Panel Premier 412/816/832 Installation Manual
56 INS159-13
Report Restore on Channel 3
On: Restore reported on channel 3.
Off: Restore not reported on channel 3.
Report Restore on Channel 4
On: Restore reported on channel 4.
Off: Restore not reported on channel 4.
Report Restore on Channel 5
On: Restore reported on channel 5.
Off: Restore not reported on channel 5.
Report Restore on Channel 6
On: Restore reported on channel 6.
Off: Restore not reported on channel 6.
Report Restore on Channel 7
On: Restore reported on channel 7.
Off: Restore not reported on channel 7.
Report Restore on Channel 8
On: Restore reported on channel 8.
Off: Restore not reported on channel 8.
The channel must also be programmed to report an event,
see “Program Outputs” on page 45.
The channel must also be programmed to report to the ARC,
see “Fast Format Reporting Channels” on page 54.
Fast Format Open/Close Channels
If either ARC 1 or ARC 2 protocols are programmed as “Fast Format
(UK)”, the channels that report an Open/Close event to the Alarm
Receiving Centre may be selected.
Report Open/Close on Channel 1
On: Open/Close reported on channel 1.
Off: Open/Close not reported on channel 1.
Report Open/Close on Channel 2
On: Open/Close reported on channel 2.
Off: Open/Close not reported on channel 2.
Report Open/Close on Channel 3
On: Open/Close reported on channel 3.
Off: Open/Close not reported on channel 3.
Report Open/Close on Channel 4
On: Open/Close reported on channel 4.
Off: Open/Close not reported on channel 4.
Report Open/Close on Channel 5
On: Open/Close reported on channel 5.
Off: Open/Close not reported on channel 5.
Report Open/Close on Channel 6
On: Open/Close reported on channel 6.
Off: Open/Close not reported on channel 6.
Report Open/Close on Channel 7
On: Open/Close reported on channel 7.
Off: Open/Close not reported on channel 7.
Report Open/Close on Channel 8
On: Open/Close reported on channel 8.
Off: Open/Close not reported on channel 8.
The channel must also be programmed to report an event,
see Program Outputs on page 45.
The channel must also be programmed to report to the ARC,
see “Fast Format Reporting Channels” on page 54.
Cancel Call Waiting Sequence
This is the number that the panel dials to disable Call Waiting. The
number can be up to 24 digits. The Cancel Call Waiting option must
also be enabled, see Communicator Options on page 52.
To Next Page
Loading...
