Texecom Premier 412 - Changing to Another Partition; Bypassing Zones; Manually Bypassing Zones; Unbypassing Zones

Premier 412/816/832 Installation Manual Operating the Alarm System
INS159-13 73
Changing to another Partition
Normally the remote keypad that you use will be assigned to a
particular partition and therefore the zone and status lights will
indicate information relevant to the assigned partition. However, you
can temporarily switch the remote keypad to a different partition so
that the zone and status lights indicate the information relevant to
the partition that you have selected. Whilst in this mode you can
also use your Access code to arm/disarm the partition you have
selected (providing you have access to the selected partition).
In order to use the cross partitioning feature, it is recommended that
the system is configured as follows:
 Cross partitioning must be enabled (see page 37).
 The user must be assigned to multiple partitions.
 The user should be set for “Local Partition Access Only”, see page
67.
 The remote keypads should only be assigned to a single
partition.
 To change to another partition, proceed as follows:
AEA AME >....
17:35.34 28/04



Premier 816
17:35.38 28/04
b@
e
b@
e

After changing to the selected partition, the remote keypad
will only remain in the selected partition for 10 seconds after
the last key press. However if an Access code is entered
whilst the remote is in this mode, the remote keypad will
remain in the selected partition for 1 minute after the last key
press.
Bypassing Zones
Manually Bypassing Zones
Bypassing a zone prevents it from causing an alarm.

After manually bypassing a zone, the bypass will remain in
place until the zone is manually unbypassed.
The bypass mode will time-out if no key is pressed for 60
seconds.
24 hour zones cannot be unbypassed if they are violated.
 To manually bypass zones, proceed as follows:
Ba Zone> 00
*OE BPAE*
E to Arm?
MEU or Otion
??

B
????
Ba Zone> 02
Zone 02 Baed

s

b@
e
b
@
e
b@
e

If the Quick Bypass feature is enabled (see page 42) you can
omit step 1 from the above procedure.
When one or more zones are bypassed the Ready light will
flash and if the system is fitted with a Premier RKP8/16 Plus
or LCD remote keypad then the Bypass light will also
illuminate.
Unbypassing Zones
To manually unbypass zones, perform the manual bypass
procedure on a zone that is already bypassed.
 24 hour zones cannot be unbypassed if they are still violated.
 If the “Reinstate Bypassed Zones on Disarm” option is enabled
(see page 37) all zones will automatically be unbypassed each
time the system is disarmed.