11-2. Communication Control Commands
11-2-1. Communication commands table
If a digital IF board has been installed in the PDS-A supply unit, the commands are as follows:
Modifying the set value of the protective function
Modifying the set value of the protective function
Modifying the set value of the protective function
Saving and recalling the set voltage and current in PRESET
Saving and recalling the set voltage and current in PRESET
Saving and recalling the set voltage and current in PRESET
Saving and recalling the set voltage and current in PRESET
Displaying the power in the voltage & current indicators
Output setting when the power is turned on
Switching between the set voltage & current display and
the output voltage & current display
Setting the output off timer
Setting the automatic cancellation time for the setting menu
display
Key lock / local function
Setting the sequence operation
Recalling preset values when the power is turned on
Output setting when the power is turned on
Main relay setting when the power is turned on
Automatic execution of the sequence program
Pausing and restarting the sequence program
Pausing and restarting the sequence program
Manual execution of the sequence program
Reading out the sequence execution status
Reading out product information
Model and specifications query
Designating local bus device
Query-dedicated PC address for device identification
when controlled by a LAN
To Next Page
