TEXIO PDS20-10A - Commands; Voltage Setting (VOLT); Current Setting (AMP); OVP Setting (OVP)

86
86
11-3. Commands
11-3-1. Voltage setting (VOLT)
This command sets or queries the output voltage.
Setting
VOLT x1
Sets the output voltage.
Application example
VOLT 5.00
Sets the output voltage to 5.00V.
Query
VOLT?
Queries the output voltage setting.
Response example
VOLT 5.00
Indicates the set output voltage is 5.00V.
Remarks
"x1" is a decimal or integer number. Digits less than the setting resolution are rounded off.
◆ For details about the setting range, see “Appendix C. SPECIFICATIONS”.
If the set value exceeds the range, the maximum value will be given.
11-3-2. Current setting (AMP)
This command sets or queries the output current.
Setting
AMP x1
Sets the output current.
Application example
AMP 5.00
Sets current to 5.00A.
Query
AMP?
Queries the output current setting.
Response example
AMP 5.00
Indicates the set output current is 5.00A.
Remarks
"x1" is a decimal or integer number. Digits less than the setting resolution are rounded off.
◆ For details about the setting range, see “Appendix C. SPECIFICATIONS ”.
If the set value exceeds the range, the maximum value will be given.
11-3-3. OVP setting (OVP)
This command sets or queries the OVP (over-voltage protection) value.
Setting
OVP x1
Sets the OVP.
Application example
OVP 5.00
Sets the OVP value to 5.00V.
Query
OVP?
Queries the OVP value.
Response example
OVP 5.00
Indicates the set OVP value is 5.00V.
Remarks
"x1" is a decimal or integer number. Digits less than the setting resolution are rounded off.
◆ For details about the setting range, see “Appendix C. SPECIFICATIONS”.
If the set value exceeds the range, the maximum value will be given.
11-3-4. UVP setting (UVP)
This command sets or queries the UVP (under-voltage protection) value.
Setting
UVP x1
Sets the UVP value.
Application example
UVP 5.00
Sets the UVP value to 5.00V.
Query
UVP?
Queries the UVP value.
Response example
UVP 5.00
Indicates the set UVP value is 5.00V.
Remarks
"x1" is a decimal or integer number. Digits less than the setting resolution are rounded off.
◆ For details about the setting range, see “Appendix C. SPECIFICATIONS”.
If the set value exceeds the range, the maximum value will be given.
11-3-5. OCP setting (OCP)
This command sets or queries the OCP (over-current protection) value.
Setting
OCP x1
Sets the OCP value.
Application example
OCP 5.00
Sets the OCP value to 5.00A.
Query
OCP?
Queries the OCP value
Response example
OCP 5.00
Indicates the set OCP value is 5.00A.
Remarks
"x1" is a decimal or integer number. Digits less than the setting resolution are rounded off.
◆ For details about the setting range, see “Appendix C. SPECIFICATIONS”.
If the set value exceeds the range, the maximum value will be given.