Thales V6000 - Page 4

DSM Installation and Configuration Guide
Copyright 2009 - 2020 Thales Group. All rights reserved.
3
Access the DSM Command Line Interface (CLI) 28
Configure network settings 29
Configure a bonded NIC device 31
Bonding driver modes 32
Enable DHCP on bond0 interface 33
Configure NTP, time zone, date, time 33
Configure the hostname 34
Generate DSM Certificate Authority and create ACS 34
Configuring IPMI 37
Verify Web Access 38
Upload a license file 39
Enable remote administration 39
Add more CLI administrators (optional) 40
Full Disk Encryption 40
Set boot passphrase 40
Recovering a lost passphrase 42
Configuring IPMI 44
IPMI Ports 44
Configuring IPMI on the DSM 44
Configuring High Availability for V6100 45
Chapter 3: DSMV6000 Hardware Appliance 46
Overview 46
Configuring a V6000 Appliance 46
Configuring the DSM via DHCP 46
Configuring DSM with DHCP 46
Configure appliance with DHCP enabled 47
Configuring a DSM v6000 via Static IP Addressing 47
Configuring a DSM v6100 via Static IP Address 47
Configure appliance with static IP address enabled 48
Assumptions 48
DSM Installation Checklist 48
Pre-configuration tasks 50
Specify host name resolution method 50
Configure DSM ports 50
Configuration Tasks 50
Connect to the V6000 appliance 50
Access the DSM Command Line Interface (CLI) 51
Configure network settings 52
Configure a bonded NIC device 53