Thinkware H100 - Items to Check after Mounting

© 2016 THINKWARE. All rights reserved.
Confidential Restricted
Items to check after mounting
NO Items to check Details
1 Lens protection vinyl
Check if the front/rear lens protection vinyl is removed.
2 Check a holder
From the front of the car, ensure there are no bubbles in the tape wrapping around
the holder.
3 Front/rear power supply
After powering up the dash cam, ensure the front/rear camera LEDs are lit.
4 Front/rear video Record for about two to three minutes and use the PC viewer to check the recording.
5 Check the camera angle
Check the front/rear video and see if you can see 1/8 to 1/4 of the bonnet.
6
Parking/event/motion
recording
Try to power off the car, and ensure you can enter the parking recording mode.
Check if impact/motion recording is activated in parking recording mode.
7 FM radio
Check if FM radio has noise. If there is too much noise in the radio, apply a ferrite
core to the hardwiring cable.
(You made a detour around the rear cable, but the problem persists.)
8 GPS/DMB
Scan the GPS/DMB channels and ensure they are received properly.
Check the separation to the navigation system and mount a ferrite core at the input
to the rear camera.
9 Door lock
Check how far away the door lock can receive the signals.
Separate the door lock receiver and mount a ferrite core at the input to the rear
camera.
32