Thinkware H100 - Overview of the Sequence for Mounting

© 2016 THINKWARE. All rights reserved.
Confidential Restricted
Overview of the sequence for mounting rear camera _ SUV
01. Check whether the rear camera is operating properly by connecting it to the terminal.
02. Select a good location for the rear camera attachment and attach it.
03. Make temporary wirings of the rear camera cables to the terminal.
04. Arrange the wires. (A pillar)
05. After removing the weather strip on the front passenger seat and insert the cable. (Insert the cable while
recovering the weather strip.)
06. Arrange the wires. (B pillar)
07. After removing the weather strip on the rear right passenger seat and insert the cable. (Insert the cable
while recovering the weather strip.)
08. Arrange the wires. (C pillar)
09. Remove the top of the trunk weather strip.
10. Remove the trunk door trim.
11. Remove the fixing hook from the indoor ceiling.
12. Neatly arrange the cables that pass through the C pillar. (While recovering the weather strip, insert the
rear camera cable.)
13. Disconnect the tube from the trunk.
14. Ensure the rear camera cable penetrates the trunk connection tube.
15. Recover the trunk connection cable.
16. Attach the rear camera/arrange the wires (Indoor ceiling and door trim)
17. Perform an operation test for a rear camera (Test items: rear video recording check)
27