THOMSON MEC 310#GENSET CONTROLLER User Manual

MEC 310 GENSET CONTROLLER
PM075 REV 2 09/08/20 Page 109 THOMSON TECHNOLOGY
6700 Diode compensation
No. Setting Min. setting Max. setting Factory
setting
6700 Diode compensation Set point 0V 1V 0V
6950 Parameter group 1
No. Setting Min. setting Max. setting Factory
setting
6950 Parameter group 1 Enable OFF ON OFF
6960 Parameter group 2
No. Setting Min. setting Max. setting Factory
setting
6960 Parameter group 2 Enable OFF ON OFF
6970 Parameter group 3
No. Setting Min. setting Max. setting Factory
setting
6970 Parameter group 3 Enable OFF ON OFF
6980 Sleep mode
No. Setting Min. setting Max. setting Factory
setting
6981 Sleep Timer 0 sec. 1800 sec. 600 sec.
6982 Sleep ON/OFF OFF ON OFF
The sleep mode is a standstill power save mode. If the engine is stopped and nothing has
happened within the time setting, the unit will enter sleep mode, i.e. the most power consuming
functions (e.g. display) are turned off. As soon as an event occurs (a button is activated, the input
state changes), the sleep mode is ended.
7090 Simple test function
No. Setting Min.
setting
Second
setting
Max.
setting
Factory
setting
7091 Activation Set point Digital input Button Digital input
or button
Button
7092 Timer Timer 0.0 s - 990.0 s 5.0 s
7093 Enable Enable OFF - ON ON
If a parameter list is enabled, the parameters marked (PX) are available in the
display parameter list.
The parameter 6700 can add an offset to the supply voltage measurement
displayed. This can be useful, if a diode is mounted in the supply connection.

THOMSON MEC 310#GENSET CONTROLLER Specifications

General

Brand	THOMSON
Model	MEC 310#GENSET CONTROLLER
Category	Controller
Language	English